MTC200 bed base with legs, full view
Detail of the 38 mm slats in blocks of two on rubber supports
Corner of the MTC200 with the double frame and the leg

Fixed slatted bed base MTC200

High-end bed base designed for flexible mattresses, such as latex ones. It helps them adapt to give the best sleeping position, with outstanding breathability.

  • 60×20mmouter frame tube
  • 38mmbeech slat in blocks of two
  • 4/5slat tilt
  • 8cmbed base height
  • 3 years warranty
  • Made in Granollers (Spain)

Full specifications

Frame
Sturdy, with a double frame. The outer frame and the cross support bars are 60×20 mm tube. The rubber supports that hold the slats are inserted into the inner frame, made of 30×30 mm tube. In sizes over 90 cm wide, a 30×30 mm center bar acts as lengthwise reinforcement.
Bed base height
8 cm.
Legs
Not included. Ready for 4 round legs that screw into the 60×20 mm tube cross bars.
Slats
38 mm natural beech plywood in flexible blocks of two, gray melamine finish.
Slat fixing
BEDS rubber supports, anchored to the top of the bed base. They let the slats tilt and move according to weight and pressure points.
Tilt
4/5.
Warranty
3 years.

Comparison of 60×20 tube bed bases

MTC200This modelA200MTP200TAPIS200
Surface38 mm slats in blocks of two120 mm slats38 mm slats in blocks of three10 mm board upholstered in black 3D fabric
SupportsBEDS rubberPELDPELDBoard resting on the frame, not fixed
Tilt
Height8 cm6 cm6 cm6 cm

We'll email it to you

Leave your email and we'll send you the download link. If you run a shop, we'll also tell you about our trade terms.