MTP200 bed base with legs, full view
Close-up of the 38 mm slats in blocks of three
Detail of the central zone and the double frame of the MTP200

Fixed slatted bed base MTP200

High-end bed base with a large slat surface. It provides flexibility, a solid base for the mattress and plenty of breathability.

  • 60×20mmouter frame tube
  • 38mmbeech slat in blocks of three
  • 3/5slat tilt
  • 6cmbed base height
  • 3 years warranty
  • Made in Granollers (Spain)

Full specifications

Frame
Double frame. The outer frame and the cross support bars are 60×20 mm tube. The plastic supports that hold the slats are inserted into the inner frame, made of 30×30 mm tube. In sizes over 90 cm wide, a 30×30 mm center bar acts as lengthwise reinforcement.
Bed base height
6 cm.
Legs
Not included. Ready for 4 round legs that screw into the 60×20 mm tube cross bars, which run from end to end of the bed base.
Slats
38 mm natural beech plywood in flexible blocks of three, gray melamine finish.
Slat fixing
PELD plastic slat holders, solid and silent, fixed to the top of the bed base.
Tilt
3/5.
Warranty
3 years.

Comparison of 60×20 tube bed bases

MTP200This modelA200MTC200TAPIS200
Surface38 mm slats in blocks of three120 mm slats38 mm slats in blocks of two10 mm board upholstered in black 3D fabric
SupportsPELDPELDBEDS rubberBoard resting on the frame, not fixed
Tilt
Height6 cm6 cm8 cm6 cm

We'll email it to you

Leave your email and we'll send you the download link. If you run a shop, we'll also tell you about our trade terms.